Linux Kernel up to 6.18.54/7.2.8 Inode evict_inodes locking

Summaryinfo

A vulnerability was found in Linux Kernel up to 6.18.54/7.2.8. It has been rated as problematic. This affects the function evict_inodes of the component Inode. Performing a manipulation results in locking. This vulnerability is identified as CVE-2026-98924. The attack can be initiated remotely. There is not any exploit available. Upgrading the affected component is advised.

Detailsinfo

A vulnerability classified as problematic has been found in Linux Kernel up to 6.18.54/7.2.8. This affects the function evict_inodes of the component Inode. The manipulation with an unknown input leads to a locking vulnerability. CWE is classifying the issue as CWE-667. The product does not properly acquire or release a lock on a resource, leading to unexpected resource state changes and behaviors. This is going to have an impact on availability. The summary by CVE is:

In the Linux kernel, the following vulnerability has been resolved: fs: avoid repeated scans in evict_inodes() We observed hung tasks when users attempted to unmount a filesystem after its disk had been removed while still in use. During device removal, fs_bdev_mark_dead() calls evict_inodes() while holding s_umount. Each time evict_inodes() drops s_inode_list_lock to reschedule, it restarts the walk from the head of s_inodes. With many referenced inodes at the head of the list, these restarts repeatedly scan the same inodes without reclaiming them. This can keep s_umount held for a long time, blocking concurrent umount attempts and triggering hung-task reports. Keep the current inode, already marked I_FREEING, out of the disposal batch until s_inode_list_lock is reacquired. Resume the walk from this inode and dispose of it in a later batch or at the end of the walk. The zero-refcount and state checks under i_lock allow this walker to claim the inode by setting I_FREEING and removing it from the LRU. Other reclaimers skip the inode, leaving this walker responsible for eviction. Only evict() removes it from s_inodes, so keeping it out of the disposal batch ensures that it remains on the list while the lock is dropped. After reacquiring the lock, reading its current next pointer accounts for concurrent removal of following inodes. The existing inode lifetime rules prohibit acquiring a reference to an inode marked I_FREEING or I_WILL_FREE. __iget() requires its caller to hold i_lock and establish that taking a reference is valid. Inode lookup and igrab() check these flags under i_lock when acquiring a reference from zero. ihold() requires an existing reference, which would keep i_count nonzero and prevent this walker from claiming the inode. These rules already allow iput_final() and the inode shrinker to release i_lock after setting I_FREEING and before eviction completes. A temporary __iget() reference would also keep the inode on the list, but its release must preserve last-reference handling. Another user can acquire a reference, update lazy timestamps and drop its reference while the pin is held. If the pin becomes the last reference, dropping it with atomic_dec_and_test() and evicting directly bypasses iput()'s lazytime handling and can lose those timestamp updates. Releasing the pin with iput() preserves that handling, but does not guarantee eviction. fs_bdev_mark_dead() runs with SB_ACTIVE set, so iput() may retain the inode in cache, whereas evict_inodes() must evict eligible zero-reference inodes. The inode may also have been freed when iput() returns, so the walker cannot then use it to force eviction. Using I_FREEING preserves the existing eviction behavior without introducing an additional last-reference transition. The xfstests auto group passed on ext4 and XFS with known unrelated failures excluded. No new issues were observed, and the previously reproducible hung task no longer occurs with this patch.

It is possible to read the advisory at git.kernel.org. This vulnerability is uniquely identified as CVE-2026-98924 since 09/25/2026. The exploitability is told to be easy. It is possible to initiate the attack remotely. The exploitation needs additional levels of successful authentication. Technical details of the vulnerability are known, but there is no available exploit.

Upgrading to version 6.18.55 or 7.2.9 eliminates this vulnerability. Applying the patch e4f3e476cd4066a815ef68cd6caa1828b9c167d5/3cdc6e12ff79f0f8a3ba62d7e61474ae4b5e119a/7459c021874246c196f397686e100702f059b9e7 is able to eliminate this problem. The best possible mitigation is suggested to be upgrading to the latest version.

Statistical analysis made it clear that VulDB provides the best quality for vulnerability data.

Productinfo

Type

• Operating System

Vendor

• Linux

Name

• Kernel

Version

• 6.18.0
• 6.18.1
• 6.18.2
• 6.18.3
• 6.18.4
• 6.18.5
• 6.18.6
• 6.18.7
• 6.18.8
• 6.18.9
• 6.18.10
• 6.18.11
• 6.18.12
• 6.18.13
• 6.18.14
• 6.18.15
• 6.18.16
• 6.18.17
• 6.18.18
• 6.18.19
• 6.18.20
• 6.18.21
• 6.18.22
• 6.18.23
• 6.18.24
• 6.18.25
• 6.18.26
• 6.18.27
• 6.18.28
• 6.18.29
• 6.18.30
• 6.18.31
• 6.18.32
• 6.18.33
• 6.18.34
• 6.18.35
• 6.18.36
• 6.18.37
• 6.18.38
• 6.18.39
• 6.18.40
• 6.18.41
• 6.18.42
• 6.18.43
• 6.18.44
• 6.18.45
• 6.18.46
• 6.18.47
• 6.18.48
• 6.18.49
• 6.18.50
• 6.18.51
• 6.18.52
• 6.18.53
• 6.18.54
• 7.2.0
• 7.2.1
• 7.2.2
• 7.2.3
• 7.2.4
• 7.2.5
• 7.2.6
• 7.2.7
• 7.2.8

License

• open-source

Website

• Vendor: https://www.kernel.org/

CPE 2.3info

• 🔒
• 🔒
• 🔒

CPE 2.2info

• 🔒
• 🔒
• 🔒

CVSSv4info

CVSSv3info

CVSSv2info

Exploitinginfo

Threat Intelligenceinfo

Countermeasuresinfo

Timelineinfo

Sourcesinfo

Entryinfo

Statistical analysis made it clear that VulDB provides the best quality for vulnerability data.

Discussion