Linux Kernel up to 6.6.159/6.12.112/6.18.56/7.2.10 bnxt_en bnxt_start_xmit buffer overflow

| CVSS Meta Temp Score | Current Exploit Price (≈) | CTI Interest Score |
|---|---|---|
| 9.5 | $5k-$25k | 3.99- |
Summary
A vulnerability was found in Linux Kernel up to 6.6.159/6.12.112/6.18.56/7.2.10. It has been rated as very critical. This impacts the function bnxt_start_xmit of the component bnxt_en. This manipulation causes buffer overflow.
The identification of this vulnerability is CVE-2026-99081. It is possible to initiate the attack remotely. There is no exploit available.
Upgrading the affected component is advised.
Details
A vulnerability has been found in Linux Kernel up to 6.6.159/6.12.112/6.18.56/7.2.10 and classified as very critical. Affected by this vulnerability is the function bnxt_start_xmit of the component bnxt_en. The manipulation with an unknown input leads to a buffer overflow vulnerability. The CWE definition for the vulnerability is CWE-120. The product copies an input buffer to an output buffer without verifying that the size of the input buffer is less than the size of the output buffer, leading to a buffer overflow. As an impact it is known to affect confidentiality, integrity, and availability. The summary by CVE is:
In the Linux kernel, the following vulnerability has been resolved: bnxt_en: fix DMA mapping length for padded small packets Stefan Fleischmann reported Intel IOMMU DMA Read faults on BCM57412 NetXtreme-E NICs when transmitting packets on VLAN/macvlan interfaces: DMAR: [DMA Read NO_PASID] Request device [18:00.0] fault addr 0xfc499000 [fault reason 0x06] PTE Read access is not set bnxt_en 0000:18:00.0 eno1np0: Abandoning msg {0xb4 0x41a} len: 0 due to firmware status: 0x2000001 ... NETDEV WATCHDOG: eno1np0 (bnxt_en): transmit queue 0 timed out The fault address (0xfc499000) is on an exact 4KB page boundary, pointing to a DMA read buffer overrun. In bnxt_start_xmit(), packets smaller than BNXT_MIN_PKT_SIZE (52 bytes), such as 42-byte untagged ARP frames, are padded: if (length < BNXT_MIN_PKT_SIZE) { pad = BNXT_MIN_PKT_SIZE - length; if (skb_pad(skb, pad)) goto tx_kick_pending; length = BNXT_MIN_PKT_SIZE; } mapping = dma_map_single(&pdev->dev, skb->data, len, DMA_TO_DEVICE); ... dma_unmap_len_set(tx_buf, len, len); However, 'len' was initialized earlier to skb_headlen(skb) (e.g. 42 bytes) and is left unadjusted after padding. Consequently, dma_map_single() and dma_unmap_len_set() map and track only 42 bytes. Later, the hardware TX buffer descriptor is programmed with the padded length: txbd->tx_bd_len_flags_type = cpu_to_le32(((len + pad) << TX_BD_LEN_SHIFT) | flags | TX_BD_FLAGS_PACKET_END); The NIC DMA engine is thus instructed to read 52 bytes from a region where only 42 bytes were DMA-mapped. If skb->data ends near the boundary of a 4KB page (within 'pad' bytes of the next page), the hardware DMA read overruns into the unmapped adjacent page, triggering an IOMMU fault. This issue was exposed after commit 447cbe95ebb9 ("vlan: fix skb_under_panic and races when toggling HW VLAN offload") because reserving extra VLAN headroom rounded LL_RESERVED_SPACE from 48 up to 64 bytes, shifting skb->data offsets and potentially causing small frames to land right against page boundaries. Fix this by using skb_put_padto(skb, BNXT_MIN_PKT_SIZE) in bnxt_start_xmit(), before skb_shinfo(skb)->nr_frags is sampled, because padding might linearize the skb. This ensures skb->len and skb_headlen(skb) reflect the padded size so that dma_map_single() maps the full buffer and the descriptor length is consistent. This also removes the temporary 'pad' variable and masking logic. The padding is done after the SW USO branch, otherwise bnxt_sw_udp_gso_xmit() would account the padding as UDP payload and send it in extra segments. Note that SW USO segments are still not padded: with IPv4, a segment carrying less than 10 bytes of UDP payload (small gso_size, or a short last segment) is sent as a frame shorter than BNXT_MIN_PKT_SIZE. This is a separate issue, left for a followup patch.
The advisory is shared at git.kernel.org. This vulnerability is known as CVE-2026-99081 since 09/25/2026. The exploitation appears to be easy. The attack can be launched remotely. The exploitation doesn't need any form of authentication. Technical details are known, but no exploit is available. The price for an exploit might be around USD $5k-$25k at the moment (estimation calculated on 10/23/2026).
Upgrading to version 6.6.160, 6.12.113, 6.18.57 or 7.2.11 eliminates this vulnerability. Applying the patch cf8530a25ae92c4493e2f22981ecb46f0b66f4c8/2956aca14dd2977cd08bd2ccafae3beb8b84b268/fbd977e513971ccb4f0762a7f59eac500e474f89/5213f65a9667d3dd85db2e6df8f2e0516290db34/a51d233ccd4889aadb71dace863525cc2b00271e is able to eliminate this problem. The best possible mitigation is suggested to be upgrading to the latest version.
Several companies clearly confirm that VulDB is the primary source for best vulnerability data.
Product
Type
Vendor
Name
Version
- 6.6.159
- 6.12.112
- 6.18.0
- 6.18.1
- 6.18.2
- 6.18.3
- 6.18.4
- 6.18.5
- 6.18.6
- 6.18.7
- 6.18.8
- 6.18.9
- 6.18.10
- 6.18.11
- 6.18.12
- 6.18.13
- 6.18.14
- 6.18.15
- 6.18.16
- 6.18.17
- 6.18.18
- 6.18.19
- 6.18.20
- 6.18.21
- 6.18.22
- 6.18.23
- 6.18.24
- 6.18.25
- 6.18.26
- 6.18.27
- 6.18.28
- 6.18.29
- 6.18.30
- 6.18.31
- 6.18.32
- 6.18.33
- 6.18.34
- 6.18.35
- 6.18.36
- 6.18.37
- 6.18.38
- 6.18.39
- 6.18.40
- 6.18.41
- 6.18.42
- 6.18.43
- 6.18.44
- 6.18.45
- 6.18.46
- 6.18.47
- 6.18.48
- 6.18.49
- 6.18.50
- 6.18.51
- 6.18.52
- 6.18.53
- 6.18.54
- 6.18.55
- 6.18.56
- 7.2.0
- 7.2.1
- 7.2.2
- 7.2.3
- 7.2.4
- 7.2.5
- 7.2.6
- 7.2.7
- 7.2.8
- 7.2.9
- 7.2.10
License
Website
- Vendor: https://www.kernel.org/
CPE 2.3
CPE 2.2
CVSSv4
VulDB Vector: 🔒VulDB Reliability: 🔍
CVSSv3
VulDB Meta Base Score: 10.0VulDB Meta Temp Score: 9.5
VulDB Base Score: 10.0
VulDB Temp Score: 9.5
VulDB Vector: 🔒
VulDB Reliability: 🔍
CVSSv2
| AV | AC | Au | C | I | A |
|---|---|---|---|---|---|
| 💳 | 💳 | 💳 | 💳 | 💳 | 💳 |
| 💳 | 💳 | 💳 | 💳 | 💳 | 💳 |
| 💳 | 💳 | 💳 | 💳 | 💳 | 💳 |
| Vector | Complexity | Authentication | Confidentiality | Integrity | Availability |
|---|---|---|---|---|---|
| Unlock | Unlock | Unlock | Unlock | Unlock | Unlock |
| Unlock | Unlock | Unlock | Unlock | Unlock | Unlock |
| Unlock | Unlock | Unlock | Unlock | Unlock | Unlock |
VulDB Base Score: 🔒
VulDB Temp Score: 🔒
VulDB Reliability: 🔍
Exploiting
Class: Buffer overflowCWE: CWE-120 / CWE-119
CAPEC: 🔒
ATT&CK: 🔒
Physical: No
Local: No
Remote: Yes
Availability: 🔒
Status: Not defined
Price Prediction: 🔍
Current Price Estimation: 🔒
| 0-Day | Unlock | Unlock | Unlock | Unlock |
|---|---|---|---|---|
| Today | Unlock | Unlock | Unlock | Unlock |
Threat Intelligence
Interest: 🔍Active Actors: 🔍
Active APT Groups: 🔍
Countermeasures
Recommended: UpgradeStatus: 🔍
0-Day Time: 🔒
Upgrade: Kernel 6.6.160/6.12.113/6.18.57/7.2.11
Patch: cf8530a25ae92c4493e2f22981ecb46f0b66f4c8/2956aca14dd2977cd08bd2ccafae3beb8b84b268/fbd977e513971ccb4f0762a7f59eac500e474f89/5213f65a9667d3dd85db2e6df8f2e0516290db34/a51d233ccd4889aadb71dace863525cc2b00271e
Timeline
09/25/2026 CVE reserved10/23/2026 Advisory disclosed
10/23/2026 VulDB entry created
10/23/2026 VulDB entry last update
Sources
Vendor: kernel.orgAdvisory: git.kernel.org
Status: Confirmed
CVE: CVE-2026-99081 (🔒)
GCVE (CVE): GCVE-0-2026-99081
GCVE (VulDB): GCVE-100-425929
Entry
Created: 10/23/2026 15:58Changes: 10/23/2026 15:58 (59)
Complete: 🔍
Cache ID: 216::103
Several companies clearly confirm that VulDB is the primary source for best vulnerability data.
No comments yet. Languages: en.
Please log in to comment.